Figure 14
T he par king brak e may not hold the
machine par k ed on a slope and could
cause per sonal injur y or pr oper ty
dama ge.
Do not par k on slopes unless the wheels
ar e chock ed or block ed
Releasing the Parking Brake
Push forw ard and do wn on the parking brak e lev er
to release the parking brak e ( Figure 14 ).
Figure 15
Starting and Stopping the
Engine
Starting the Engine
1. Raise the roll bar up and loc k it into place , sit
on the seat, and fasten the seat belt.
2. Ensure that the motion controls are in the
neutral loc k ed position.
3. Set the parking brak e; refer to Setting the
P arking Brak e .
4. Mo v e the PTO (po w er tak e off) switc h to the
off position ( Figure 16 ).
Figure 16
1. Ignition switch 3. Glow plug light
2. Throttle control
4. Power take off switch (PTO)
5. Mo v e the throttle lev er midw a y betw een the
F ast and Slo w positions ( Figure 16 ).
6. T ur n the ignition k ey cloc kwise to the R un
position ( Figure 17 ).
T he glo w plug light will tur n on for 6 seconds .
Figure 17
1. Ignition switch 3. Run/glow pug
2. Off
4. Start
7. After the glo w plug indicator light g oes out,
tur n the k ey to the Star t position. W hen the
engines star ts release the k ey .
29
To Next Page
Loading...
