If y ou lea v e the k ey in the ignition s witch, someone could accidentl y star t the engine and
seriousl y injur e y ou or other bystander s.
R emo v e the k ey fr om the ignition bef or e y ou do an y maintenance.
Figure 38
Service Interval Chart
Lubrication
Greasing the Bearings and
Bushings
T he mac hine has g rease fittings that m ust be
lubricated regularly with No . 2 General Pur pose
Lithium Base Grease . If the mac hine is operated
under nor mal conditions , lubricate all bearings
and bushings after ev er y 50 hours of operation.
Bearings and bushings m ust be lubricated daily
when operating conditions are extremely dusty and
dir ty . Dusty and dir ty operating conditions could
cause dir t to g et into the bearings and bushings ,
resulting in accelerated w ear . Lubricate the g rease
fittings immediately after ev er y w ashing, reg ardless
of inter v al specified.
1. Wipe the g rease fittings clean so foreign matter
cannot be forced into the bearing or bushing .
2. Pump g rease into the fittings .
3. Wipe off ex cess g rease .
Figure 39 and Figure 40 illustrate the locations of
the g rease fittings .
Important: T he fittings on the axles of the
caster wheels ar e not illustrated. Ensur e that
y ou g r ease these fittings as w ell.
43
To Next Page
Loading...
