1. Diseng ag e the PTO , mo v e the motion control
lev ers to the neutral loc k ed position and set
the parking brak e .
2. Mo v e the throttle lev er to the Slo w position,
stop the engine , remo v e the k ey , and w ait for
all mo ving par ts to stop before lea ving the
operating position.
3. Raise the front of the mac hine and suppor t it
on jac k stands .
4. R emo v e the fasteners securing eac h roller on
y our mo w er dec k and mo v e the rollers up or
do wn as desired; refer to Figure 25 through
Figure 29 as applicable for y our mo w er .
Figure 25
All Mower Decks
1. Front roller 2. Roller shaft
Figure 26
Guardian Mower Decks Only
1. Bolt
4. Nut
2. Rear under-deck roller 5. Bracket
3. Spacer
Figure 27
Guardian Mower Decks Only
1. Bolt
3. Nut
2. Front under-deck roller 4. Bracket
Figure 28
Side-discharge Mower Decks Only
1. Bolt
4. Nut
2. Chute-side roller 5. Bracket
3. Spacer
34
To Next Page
Loading...
