Toro reelmaster 216 - Page 142

Backlapping
The cutting units may be backlapped in position on the
machine by releasing tensioning to the drive belts and
removing the capscrew securing the left end of the
carrier frame to the cutting unit. Otherwise, remove
cutting units completely before backlapping.
Connect a lapping machine to the capscrew on the left
end of reel shaft with an extension coupler and a 9/16 in.
socket. Backlap according to procedures in the Toro
Sharpening Reel and Rotary Mowers Manual Form No.
80-300-SL.
j
DANGER
Be careful when lapping the reel because
contact with the reel or other moving parts
can result in personal in ury.
Under no circumstances use a short handled
paint brush. 29-9100 Handle assembly com-
plete or individual parts are available from
your local Authorized TORO Distributor.
CAUTION
Service and Repairs Page 9 - 18 Reelmaster
®
216/216-D