________________________________________________________________________________________________________________________________________________________
________________________________________________________________________________________________________________________________________________________
________________________________________________________________________________________________________________________________________________________
Starting Problems (continued)
Condition Possible Cause Correction
Engine cranks, but does not start. Engine wiring connector or wires Repair wiring.
loose, corroded or damaged.
Engine, engine ignition, or fuel sys- See Troubleshooting section of
tem problem. Kohler Magnum Engine Service
Manual.
Interlock module faulty. Replace interlock module.
Engine cranks (but should not) Traction neutral switch out of ad- Test switch and replace if faulty.
with traction pedal out of neutral.
justment or faulty. Make sure wires are connected
to “COMMON” and “NORMALLY
OPEN” (N.O.) terminals.
Engine cranks (but should not) Cutting unit clutch switch faulty. Replace switch.
with cutting unit clutch switch ON.
Troubleshooting (Reelmaster 216) Page 6 - 10 Reelmaster
®
216/216-D
To Next Page
Loading...
