7.
Remove the brake plate assembly by
removing one
10
mm shoulder screw and
one
3/8"
washer-head screw. Place the
assembly on the mower deck and
disconnect the ground wire that goes to the
CD Pack.
page
7-6).
8.
Remove the CD Pack
(
See CD Removal,
751.I,0490.80
9.
751.1.0490.13
Snap open the air cleaner cover (catch on
left, hinge on right) and remove the air filter
element. Pop out, and retain, the
2
plastic
plugs (or spit cup) covering the carburetor
screws. Remove the
two
screws securing
the carburetor to the engine
NOTE:
Later
production
'95
carburetors use a spit cup in
place of the
2
plugs. Remove the
carburetor spitcup by pulling the ends out of
the carburetor access holes molded into the
air filter base. Disconnect the fuel line from
the carburetor. Separate the carburetor from
the engine with controls attached and set it
on the mower deck. (See Carburetor
Removal, page
5-5)
10.
On
self
propelled
models
only,
remove
the
5/16"
screw
to
remove the belt drive
cover. Remove
two
3/8"
screws with
spacers that secure the belt drive guide
bracket to the transmission. Remove the
drive belt from the pulley. The belt will stay
with the engine as the cover is removed.
Service
Section
9-9
To Next Page
Loading...
