5-31Z Master Z400 Service Manual
5
11. Replace the plastic tie holding the clutch harness to
frame.
12. Install the mower drive belt onto the electric PTO
clutch. Refer to Replacing the Mower Deck Drive
Belt page 7-24.
13. Plug in the engine wiring harness (Fig. 323).
ENGINE
Fig 323 PICT-0283
14. Connect the red wires to the starter solenoid (Fig.
324).
15. Connect the fuel hose clamp onto the fuel hose
located at the fuel pump (Fig. 325).
Fig 325 PICT-0330
Fig 324 PICT-0331
16. Turn the fuel shut-off valve to the “On” position (Fig.
326).
Fig 326 PICT-0329
To Next Page
Loading...