3-11Z Master Z400 Service Manual
3
9. Install the wheel bearing (Fig. 067).
Fig 067 PICT-0022 rev
Fig 069 PICT-0024 rev
11. Repeat steps 8-10 for the other side of the wheel.
12. Install one spacer nut onto the caster axle (Fig. 069).
Fig 068 PICT-0021 rev
10. Install the caster seal (Fig. 068).
Fig 070 PICT-0025 rev
13. Insert caster axle/nut assembly into the wheel hub
and install the second spacer nut (Fig. 070).
CHASSIS
Note: Spacer nuts should be installed an equal
distance onto each end of the caster axle.
To Next Page
Loading...