3-30 Z Master Z400 Service Manual
3
CHASSIS
8. Raise deck lift lever assembly until deck mount
swivels rest against deck rod jam nuts. Install HOC
pin into deck lift plate HOC holes that correspond to
the 3” (7.62cm) HOC position (Fig. 135).
Fig 135 PICT-0068
9. Install lower “stop” bolt through inner and outer deck
lift plates. Install nylock nut and tighten until hex nut
and bolt are seated rmly against the deck lift plates.
DO NOT over-tighten or deck lift plates will deform
inward causing HOC pin assembly to bind (Fig. 136).
Fig 136 PICT-0069
B
A
Fig 134 PICT-0067
7. Align rear deck mount swivels with ends of deck lift
rods (Fig. 134).
Fig 133 PICT-0066
6. Rotate deck lift plate (inner) downward until lower
mounting holes line up with hole in carrier frame and
deck lift plate (outer). From the outside of the frame
install hex bolt, spacer, and anged lock nut as
shown. Tighten bolt (Fig. 133).
A B
C
A. Hex bolt C. Spacer
B. Flange locknut
A. Swivel B. 3” (7.62mm)
HOC location
To Next Page
Loading...