Toro Z Master Z400 Series - Page 95

5-8 Z Master Z400 Service Manual
5
ENGINE
7. Align the clutch stop rod with the slot of the electric
PTO clutch (Fig. 235). Rotate the clutch stop rod into
the slot on the clutch. Tighten the stop rod mounting
bolt.
Fig 235 PICT-0104a
8. Install the mower drive belt. Refer to Replacing the
Mower Deck Drive Belt on page 7-24.
9. Plug the clutch pigtail harness into the main harness
(Fig. 236).
Fig 236 PICT-0100a
Fig 237 PICT-0099a
10. Replace the plastic tie holding the clutch harness to
frame (Fig. 237).
Fig 234 PICT-0106a rev
6. Install the hydro pump drive belt (Fig. 234).