A ÷ L
Screen 20: If your VCR stopped phying the tape after testing,
sdect YES and press ENTER. Screen 21 appears.
[fvour VCR did nor stop playing the tape after resting and
-ou want re res_the same code again, selectTEST THIS
(_ODE AGAIN and press ENTER.
[fyou want re rest a dif'fcrenr code, select NO and press
ENTER. Screen 19 appears.
Note: Ighlig VCR_ reqldre tegtillgmosethanonecode
Screen 22: Corlgratulations! You ha_e successf'uly completed
TV Guide On Screen system setup. Press ENTER co
display screen 23.
Screen 23: This screen provides helpful infiarmacion on using
your TV Guide Oi1 Screen system.
Press ENTER co exit d_eTV Guide On Screen setup and
watch TV.
Screen 21: Review the setup infiarmation displayed on your TV
screen (an example is shown bdow).
If the infi)nnafion on your TV screen is correct for your
setup, select YES, END SETUP and press ENTER. Screen
22 appears.
If the infbrmation is incorrect, sdect NO, REPEAT
SETUP PROCESS and press ENTER. Screen 1 appears.
TV auite On Screen Reminter
The TV Guide On Screen system receives program listings
data through your Cable or over-the-air video signal In
order to receive regular program listings, please remember to
do the {blowing:
1. Leave the TV in standby mode when it is not in use
(such as overnight or when you are not watching it)
by turning it OFF but leaving the power cord
plugged in.
2. If you have a (;able box connected, leave it ON.
3. [fg)u have a VCR connected, turn it OFF when not
in use. (Do not unplug the power cord.) See page 13
fbr VCR connecuon instructions.
If you have more than one (;able syscernin your area,
you may be prompred to sdecc which Cable sys_ern's
program data to download. If so prompEed, follow the
on-screen instructions.
÷
Hg4(E)036-sg(5-TVGsetup)
39
Copyright @ 2004 TOSHIBA CORPORATION, All rights reserved,
÷
8/3/04, 4:02 PM
39
r
To Next Page
Loading...
