Toshiba B-EX4 - Fine adjustment value setting; ADJUST SET

5. SYSTEM MODE EO18-33027
5.5 PRINTER PARAMETER FINE ADJUSTMENT
5-37
5.5 Fine adjustment value setting/ ADJUST SET
 Outline of Printer Parameter Fine Adjustment
In the Printer Parameter Fine Adjustment mode, you can fine adjust each parameter, such as Print
tone, Print start position, Threshold, etc. which are set by the PC command. This is useful when using
several types of media by turns or when the print start position or cut/strip position is required to be fine
adjusted.
The Printer Parameter Fine Adjustment menu contains the following.
MENU ITEM
System Mode / SYSTEM MODE
<3>Fine adjustment value setting / <3>ADJUST SET
Feed / FEED ADJ.
Cut position / CUT ADJ.
Back feed / BACK ADJ.
X direction position / X ADJUST
Density adjustment (Thermal transfer)
/ TONE ADJ.(TRANS.)
Density adjustment (Direct thermal)
/ TONE ADJ.(DIRECT)
Ribbon (Rewinder) / RBN ADJ.<FW>
Ribbon (Feeder) / RBN ADJ.<BK>
Reflective sensor fine tune
/ THRESHOLD <REFL.>
Transmissive sensor fine tune
/ THRESHOLD <TRANS.>