4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO18-33027
(Revision Date: Aug. 24, 2011)
4.1 DISC CUTTER (B-EX204-QM-R)
4- 7
11. Attach the Cutter Cover to the Cutter Unit with the Plastic Head Screws.
12. Restore the Platen Holder Cover.
NOTE: The strip plate is not used. Keep it safe for future use.
13. Close the Print Head Block and Ribbon Shaft Holder Plate.
NOTE: DO NOT excessively push down the print head block to close it. Doing so may cause a failure of the
print head block or damage to the print head.
Plastic Head Screw
Cutter Cover
Cutter Unit
Platen Holder Cover
To Next Page
Loading...
