4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO18-33027
(Revision Date: Aug. 24, 2011)
4.5 RTC/USB Host Interface Board (B-EX700-RTC-QM-R)
4-34
4. Unfold the upper tabs of the Blind Plate indicated by the arrow, then pull and remove the Blind Plate
from the printer back.
5. Fit the USB Host Connector of the RTC/USB Host Interface Board into the slot from the inside, and
secure it with the two M-3x6 screws from the outside, as shown below.
Blind Plate
Tab
Tab
USB Host Connector
M-3x6 Screw
M-3x6 Screw
To Next Page
Loading...
