5. SYSTEM MODE EO18-33027
5.3 SELF-DIAGNOSTIC TEST
5-4
• Menu operation procedure example
English Procedure
Press [FEED] key and [RESTART] key when turning on the printer.
Display 「System Mode / SYSTEM MODE」.
Select <1>Diagnostics/<1>DIAG.」 and press [ENTER] Key.
Display 「<1>Diagnostics/<1>DIAG.」 menu.
Select 「Counter, Parameter/MAINTENANCE CONT」 and press [ENTER] Key.
Display 「Counter, Parameter/MAINTENANCE CONT」 menu.
Select 「Print method / PRINT TYPE」 and press [ENTER] Key.
Display 「Print method / PRINT TYPE」 menu.
Setting printing method.
Display「Counter, Parameter/MAINTENANCE CONT」 menu by pressing [ENTER].
Press [DOWN] Key, select 「Cut type/ CUT TYPE」 and press [ENTER] Key.
Display 「Cut type / CUT TYPE」 menu.
Setting 「Cut type / CUT TYPE」.
Display「Counter, Parameter/MAINTENANCE CONT」 menu by pressing [ENTER].
Press [DOWN] Key, select 「Print / CHECKING & PRINT」 and press [ENTER] Key.
Print 「Counter, Parameter/MAINTENANCE CONT」.
Printing
Display “PRINTING”.
Normal printing
Display 「Counter, Parameter/MAINTENANCE CONT」 menu.
Print error occur
Display the error message and stop issuing.
The error LED turns on and the online LED
turns off.
Display 「Counter, Parameter/MAINTENANCE CONT」 menu by pressing [ENTER]
Key or [CANCEL] Key.
The error LED turns off and the online LED turns on.
After recovery from error, printer does not start printing automatically.
To Next Page
Loading...
