1. PRODUCT OVERVIEW ENGLISH VERSION EO1-33114
1.1 Introduction
2
1. PRODUCT OVERVIEW
1.1. Introduction
1.2 Features
1.3 Unpacking
Thank you for choosing the TEC B-EX4T3 series barcode printer. This
Owner’s Manual contains from general set-up through to how to confirm
the printer operation using a test print, and should be read carefully to
help gain maximum performance and life from your printer. For most
queries please refer to this manual and keep it safe for future reference.
Please contact your Toshiba Tec representative for further information
concerning this manual.
This printer has the following features:
The print head block can be opened providing smooth loading of
media and ribbon.
Various types of media can be used as the media sensors can be
moved from the center to the left edge of the media.
Web based functions such as remote maintenance and other advanced
network features are available.
Superior hardware, including the specially developed 23.6 dots/mm
(600 dots/inch) thermal print head which will allow very clear print at
a printing speed of 2, 3, 4, 5 or 6 inches/sec.
Besides the optional Cutter Module, there is also an optional Peel off
Module, Centronics I/F card, Expansion I/O Card, Narrow width
platen kit.
Unpack the printer as per the Unpacking Instructions supplied with the
printer.
NOTES:
1. Check for damage or scratches
on the printer. However,
please note that Toshiba Tec
shall have no liability for any
damage of any kind sustained
during transportation of the
product.
2. Keep the cartons and internal
packing for future
transportation of the printer.
To Next Page
Loading...
Need help?
General
