Page 5
1.3 Desktop printer: B-FV4D / B-FV4T
Counter reading for ‘0.1 km counter’ (FEED1) and ‘cm/inch counter’ (FEED2)
Test print
1. Turn off the printer and insert full-width media (104 mm).
2. Press the [FEED] key as you switch on the printer. The LED 1 and 2 will illuminate
in the following order:
orange → green → other colours
3. Release the [FEED] key when LED 1 is illuminated orange and LED 2 is
illuminated green.
4. Press the [FEED] key again.
5. Once the printer has produced the test print, it will be in DUMP mode.
6. To return to the ONLINE mode, turn off the printer and turn it back on again.
The counter reading is now printed out.
To Next Page
Loading...
Need help?
General
