Page 6
1.4 Desktop printer: B-EV4D / B-EV4T
Test print
1. Turn off the printer and insert media.
2. Press the [FEED] key as you switch on the printer. The LED will light up in the
following sequence: green (flashing) → red (flashing) → orange (flashing) →
orange → red → green
3. Release the [FEED/PAUSE] key when the LED illuminate green. The printer
carries out an automatic test and then changes to DUMP mode.
4. Next, switch the printer off and then on again, so that the printer is placed in
ONLINE mode.
The counter reading is now printed out.
To Next Page
Loading...
Need help?
General
