3.7 Replacing the Feed Gap Sensor Ass’y and Label Guide --------------------------------------- 3-10
3.8 Replacing the Black Mark Sensor Ass’y------------------------------------------------------------- 3-12
3.9 Replacing the Print Head Ass’y------------------------------------------------------------------------ 3-13
3.10 Replacing the Head Open Micro Switch------------------------------------------------------------- 3-14
3.11 Replacing the Ribbon Motor and Ribbon Sensor ------------------------------------------------- 3-15
3.12 Replacing the Feed Button Ass’y --------------------------------------------------------------------- 3-17
4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT --------------------------------------4-1
4.1 Set Up Memory Module
(Option: B-SV704-E1M/E2M/E3M/E4M/E6M/E8M-QM-R) ---------------------------------------4-1
4.2 Install the Strip Module (Option: B-SV404-H-QM-R)-----------------------------------------------4-3
4.3 Install the Cutter Module (Option: B-SV204-QM-R) ------------------------------------------------4-5
5. TROUBLESHOOTING --------------------------------------------------------------------------------------------5-1
6. MAINTENANCE-----------------------------------------------------------------------------------------------------6-1
CAUTION!
1. This manual may not be copied in whole or in part without prior written permission of TOSHIBA
TEC.
2. The contents of this manual may be changed without notification.
3. Please refer to your local Authorised Service representative with regard to any queries you
may have in this manual.
Copyright © 2007
by TOSHIBA TEC CORPORATION
To Next Page
Loading...
