4-3
4.2 Install the Strip Module (Option: B-SV404-H-QM-R)
1. Open the top cover ass’y.
2. Remove two screws for hinge support and one screw for memory module cover in
lower cover ass’y.
3. Remove 6 screws on the lower inner cover.
4. Hold the lower cover ass’y and lift up the top cover open levers to separate the
lower inner cover and the lower cover ass’y. (Please refer to section 3.1 )
5. Connect the harness of strip module through the slot of lower inner cover.
6. Lift up the lower inner cover to gently push strip panel into the two concaves of
lower cover front side.
Note : Must lift up the lower inner cover first, then, the strip module could be
installed into the concave of lower inner cover.
Slot
Concave
To Next Page
Loading...
