Toshiba B-SV4T SERIES - Replacing the Feed Gap Sensor Assy and Label Guide

3-10
3.7 Replacing the Feed Gap Sensor Ass’y and Label Guide
1. Please refer to 3.1 for disassembling the lower cover ass’y and lower inner
cover.
2. Disconnect all harnesses from the main PCB ass’y .
3. Turn the lower inner cover upside down.
4. Screws off 4 screws and remove the plastic laminate.
5. Screws off 2 screws from a Label Guide Rack Fixing Plate and 2 from a gap
sensor PCB then remove the feed gap sensor ass’y.
Screws
Screws
Screw
Screw
Feed Gap Sensor Ass’
y
Plastic Laminate
Lower Inner Cove
r
Label Guide
Rack Fixing
Plate
Screw