3-8
3.6 Replacing the Stepping Motor Bracket / Metal Assembly
and Stepping Motor
1. Please refer to 3.1 for disassembling the lower cover ass’y and lower inner
cover.
2. Disconnect all harnesses from the main PCB ass’y .
3. Turn the lower inner cover upside down.
4. Remove 2 screws that fixed the stepping motor on the bracket.
5. Remove the stepping motor.
6. Remove 8 screws of the stepping motor bracket / metal assembly.
Screws
Screws
Screws
Stepping
Motor
Motor Bracket/Metal Assembl
To Next Page
Loading...
