Toshiba B-SV4T SERIES - Replacing the Lower Inner Cover

3-4
3.2 Replacing the Lower Inner Cover
1. Refer to 3.1 to remove the top cover ass’y.
2. Remove the 6 screws on lower inner cover. Turn the printer upside down,
remove the 2 screws of hinge holder, and 1 screw of memory module cover.
3. Disconnect all harnesses from Main PCB ass’y. Lift up the lower inner cover.
4. Replace the lower inner cover.
5. Reassemble in reverse procedures.
Lower inner cover
Screws
Screws
Memory module
cover
Screw
Screw of
hinge holder
Screw of
hinge holder