4-6
3. Plug in the Cutter Driver IC A3952SB at U14 socket on the main PCB ass’y .
4. Open the printer top cover ass’y by pushing the top cover open levers to the
paper outlet direction. The top cover support will hold the printer top cover
ass’y.
5. Open the top cover ass’y to the ultimate open angle. Push the top cover support to
the communication port direction to disconnect the lower inner cover and top cover
support.
6. Pull up the front cover from the lower cover ass’y.
7. Remove the 6 screws in lower inner cover.
8. Lift up the lower inner cover from the lower cover ass’y.
Cutter Driver
IC A3952SB
Front Cove
To Next Page
Loading...
