Touch Screen Controller Owner's Manual
12
-EN
Glossary
Terminology Description
Thermo off When the temperature of a room reaches the set temperature, the outdoor unit compressor stops
to switch from cooling/heating to fan operation. Although the indoor unit (air conditioner) is in
operation, the outdoor unit repeatedly turns ON/OFF depending on the room temperature.
During power peak cut control Control to cut the peak of electric power usage.
Flap A part that changes the air direction at the outlet. It is also called a louver.
Air to Water Heat Pump This model can control water heating and air conditioning.
This model is only available outside the country.
It is described as ATW or ESTIA in some parts of the manual.
Room Air Conditioner (home) (RAC) This is a household air conditioner. It can be connected to a unit via specialized equipment.
It is described as RAC in some parts of the manual.
ON/OFF unit Indicates devices that cannot control or monitor the set temperature or operation mode among the
managed devices.
Main equipment includes air to air heat exchangers, ventilation fans, etc.
Leak detector (LD) Refrigerant leak detector
This can be displayed on the layout screen for units.
If you want to display it, you need to set it in the Section Configuration Software.
For details, refer to the manual for the Section Configuration Software.
It is described as LD in some parts of the manual.
FS unit This device controls refrigerant
This can be displayed on the layout screen for units.
If you want to display it, you need to set it in the Section Configuration Software.
For details, refer to the manual for the Section Configuration Software.
To Next Page
Loading...
