Toshiba BMS-CT2560U-E - Page 42

Touch Screen Controller Owner's Manual
42
-EN
● NOTE
• For the setting of [(1)], see "Local Remote Controller Lock" (P.50).
• For the setting of [(2)], see "Set Operation Details" (P.52).
• If there is no corresponding function, that item is not displayed.
3
Fan Speed Tap to switch to the following.
● NOTE
Depending on the connected model, it may not be configurable.
4
Set temp. Tap to change the set temperature.
● NOTE
• If the operation mode is FAN, the temperature cannot be set.
•[
4-(1)] shows the indoor temperature detected by the indoor unit after partial compensation.
*Depending on conditions such as the installation site of the indoor unit, it may differ from
actual room temperature.
• In this area, icons and text are displayed, such as for frost protection, preparing for operation,
or preparing for heating operation.
Example of a model without a flap
Example of a case in which the wind direction
cannot be changed
Since you cannot set the air direction, it does not change even
if you tap it.
Because the flap is locked, you cannot change the wind
direction even if you tap it.
Example of a model where only a certain fan speed
can be set
Since you cannot change the fan speed, it does not change
even if you tap it.
No. Name Functions
(1)(1)
(2)(2)