2.Printer Setup
Preparing to use the printer ..............................................................................................18
Setup locations ....................................................................................................................................................18
When purchasing the power cable......................................................................................................................19
Connecting the AC adapter/power cable ...........................................................................................................20
Connecting to a computer...................................................................................................................................22
Turning the printer ON/OFF...............................................................................................33
Turning ON the printer ........................................................................................................................................33
Turning OFF the printer .......................................................................................................................................35
Loading the media............................................................................................................37
Media loading procedure ....................................................................................................................................38
Procedure for loading media when the cutter module is attached ..................................................................43
Procedure for loading media when the peel-off module is attached ...............................................................45
Fanfold paper loading procedure .......................................................................................................................47
Procedure for loading media when using the external media stand ................................................................49
Loading the ribbon (thermal transfer method)....................................................................53
Adjusting the position of the media detection sensor ..........................................................58
Confirming the position of the transmissive sensor (fixed)...............................................................................58
Adjusting the position of the reflective sensor (movable).................................................................................59
To Next Page
Loading...
