26 - English
System Setup
Auto Setup
You do not need to preset the stations if you have
already set them automatically (see Plug & Auto Set Up
on page 24).
Your DVD Recorder & VCR contains a built-in tuner
used to receive television broadcasts.
You must preset the stations received through the tuner.
This can be done:
• Plug & Auto Set up (see page 24)
• Auto Setup
• Manual Setup (see page 27~28)
1
With the unit in Stop mode/No Disc mode, press
the MENU button.
2
Press the …† buttons to select Setup, then press
the OK or √ button.
3
Press the …† buttons to select Install, then press
the OK or √ button.
4
Press the …† buttons to select Auto Setup, then
press the OK or √ button.
The message “Your data will be lost.Press [OK] to
continue, [MENU] to exit.” is displayed.
5
Press the OK button to start the auto scanning.
• The first frequency band is scanned and the first
station found is displayed and stored.
And the DVD Recorder & VCR searches for the
second station and so on.
• When the automatic scanning procedure has
finished, the DVD Recorder & VCR switches
automatically to programme 1.
• The number of stations automatically stored by
the DVD Recorder & VCR depends on the
number of stations that it has found.
6
If you wish to cancel the auto scanning before the
end, press the OK button.
• The time and date are set automatically from the
broadcast signal. If the signal is weak or
ghosting occurs, the time and date may not be
set automatically.
• Once the auto scanning procedure has finished,
some stations may have been stored more than
once; select the stations with the best reception
and delete the ones no longer required.
No Disc Setup
System
√√
Clock Set
√√
Install
√√
Language
√√
Audio
√√
Video
√√
Parental Control
√√
MOVE OK RETURN EXIT
Programme
Setup
No Disc Install
Auto Setup
√√
Manual Setup
√√
VIDEO Output CH : Ch 60
√√
MOVE OK RETURN EXIT
Programme
Setup
No Disc Auto Setup
Please wait.....
Scanning... 50%
MOVE OK RETURN EXIT
Programme
Setup
Stop
■
If your clock is set to the wrong time zone or
daylight saving, you can adjust these settings
without turning off the Auto Clock Set function.
Note
RETURNOKMOVE EXIT
Auto Setup
No Disc
Auto Setup
√√
Manual Setup
√√
Programme
Setup
Your data will be lost.
Press [OK] to continue, [MENU] to exit.
VR25SB-1-eng 5/6/05 5:33 PM Page 26
To Next Page
Loading...
