English - 55
Playback
To play a standard VHS tape, just insert it into the VCR
deck and press the PLAY button. You can turn on the
Auto Play to enable the VCR deck to play automatically
when you insert a videotape that is missing the Record
Safety Tab.
1
Insert a standard VHS tape into the VCR deck.
• When a videotape is inserted, power will turn on
automatically.
2
Press the VCR button to select the VCR mode.
3
Press the √II (PLAY/PAUSE) button on the
remote control or on the front panel of the unit to
start playback. The videotape will begin to play
automatically if the Record Safety Tab is removed
and Auto Play is turned on.
4
Press the (STOP) button on the remote control
or on the front panel of the unit to stop playback.
The Tracking adjustment removes the white lines that
sometimes appear during playback because of slight
differences in recording decks. The PROG/TRK (
/)
button will automatically align the recorded tracks with
the playback heads to solve this problem.
You may also set tracking manually.
1
Adjust Tracking Manually
During playback, press the PROG/TRK (
/)
buttons to remove white lines from the picture.
While a videotape is playing, you can enjoy a variety of
special playback features, including Still, Frame Advance,
Skip, Slow motion, and more.
❚
Pause
In Play mode, press √
II
button to still a single frame.
❚
Frame Advance
In the pause mode, press F.ADV/SKIP button to
advance to the next frame.
FPS/RPS
In Play mode, press Forward (√√) button or Rewind
(œœ) button to FPS/RPS:
• Picture Search -
Press and release repeatedly to
advance the tape forward or backward at variable
speeds.
• Jet Search - Press and hold to advance the tape
forward or backward at 7 times normal speed.
Upon release, it will resume normal playback.
❚
Skip
In Play mode, press F.ADV/SKIP button to cue
ahead exactly 30 seconds. Press F.ADV/SKIP button
repeatedly up to 4 times to cue ahead 2 minutes.
❚
Slow motion
In pause mode, press √√ button for slow motion.
Press the √√ button repeatedly to vary slow motion
speed from 1/5 to 1/30 of normal playback. Press the
PLAY button twice to resume normal viewing.
Playing back a VHS
Tape (VCR)
Tracking
Special VCR Playback
Features
■
The forward (√√) button and Rewind (œœ)
button operate slightly different with front Panel
buttons and remote control buttons. When the
√√/œœ button on the front panel is pressed
during playback, there is only one search speed
available.
Note
■
The DVD Recorder & VCR only support PAL
tape playback.
Note
VR25SB-2-eng 5/6/05 5:43 PM Page 55
To Next Page
Loading...
