English - 39
System Setup
2
The message “Please set your TV to Progressive
input. To deactivate, press [STOP] key.” will appear.
Press the OK button.
3
The message “Video Output Mode Progressive
Scan” will appear.
If your TV supports Progressive Scan, press the
P-SCAN button on the front of the DVD Recorder &
VCR to enjoy the progressive scan.
1
With the unit in Stop mode, press the P-SCAN button on
the front of the DVD Recorder & VCR.
The message “Press [Yes] to confirm Progressive
scan mode. Otherwise press [No]” will appear. Press
the œ √ buttons to select Yes, and then press the
OK button.
■
Progressive setting is only available when the
Video Out is set to Component (See page 38).
■
If the P-SCAN button on the DVD Recorder &
VCR’s front panel is pressed during playback,
the message “This function is
possible only on
stop mode” appears on the screen.
■
Progressive setting is only available when the
DVD Recorder & VCR is in stop mode.
Note
Press [Yes] to confirm Progressive scan mode.
Otherwise press [No]
Yes No
Please set your TV to Progressive input.
To deactivate, press [STOP] key.
OK
Video Output Mode
Progressive Scan
Setting up the
Progressive scan
In Component mode, you can set video output to
Progressive or Interlace, see
the table below
.
Available video output jacks are as follow.
Available Video Output Jack
Component Output
(Y, Pb, Pr)
AV1 Scart
R, G, B
Composite
X
O
X
O
O
O
O
(TV in progressive mode)
X
X
X
X
X
O
X
O
O
O
O
AV2 Scart
Composite Video out
S-Video out
Composite
Setting mode
RGB
Mode
Output jack
P-SCAN off mode
(Interlace mode)
P-SCAN
on mode
Component mode
VR25SB-1-eng 5/6/05 5:33 PM Page 39
To Next Page
Loading...
