e-STUDIO200L/202L/230/232/280/282 PAPER FEEDING SYSTEM June 2004 © TOSHIBA TEC
9 - 18
[H] Bypass tray
[I] Paper size detection sensor
(1) Take off the bypass unit
(! P.9-17 "[G] Bypass unit").
(2) Disconnect 1 connector. Remove 2 screws
and take off the bypass tray.
Note:
The bypass tray is removable without taking
off the bypass unit from the equipment.
Fig.9-22
(3) Pull out the hinge assembly from the bypass
tray.
Fig.9-23
(1) Take off the bypass tray.
(! P.9-18 "[H] Bypass tray").
(2) Remove 3 screws and take off the bypass
tray upper cover.
Fig.9-24
Bypass tray
Hinge
ScrewScrew
Bypass tray
upper cover
To Next Page
Loading...
