7 TopAccess Administrator Mode
196 Setting up from TopAccess
3
In the Print Service submenu page, set the Print Service settings as
required.
y In the Print Service submenu page, you can set the following:
P.197 “Setting up the Raw TCP Print”
P.197 “Setting up the LPD Print”
P.197 “Setting up the IPP Print”
P.199 “Setting up the FTP Print”
P.199 “Setting up the NetWare Print”
P.200 “Setting up the Email Print”
4
Click [Save].
y The confirmation dialog box appears.
If you want to restore the current settings without saving the changes, click [Cancel].
Clicking [Cancel] cannot restore the defaults. This can only clear the changes and
restore the current settings before saving the changes.
5
Click [OK] to apply the changes.
When using the Internet Explorer, the settings that are displayed in each field may not be
changed even if you change the settings and click [Save]. However, the settings have
been changed in the equipment. In that case, click the Print Service submenu then the
page displays the current settings in each field.
To Next Page
Loading...
