110
3.SETTING OF BASIC COPY MODES
4.Selecting Finishing Modes (Cont.)
3
Hole punch mode (optional)
When the Hole Punch Unit (optional) is installed to the finisher (optional), you can punch holes in the cop-
ies.
• The available copy paper sizes for this mode are LD, LG, LT, LT-R and COMP.
• The paper weight applicable for this mode is 17 lb. Bond to 110 lb. Index.
• Special paper such as OHP films or sticker label cannot be used for hole punching.
1
Place paper in the drawer(s).
• When using this mode in bypass copying, specify the paper size in advance. ( P.75 “3.Bypass Copying”)
2
Place the original(s).
3
Press the finisher button on the basic menu.
4
Press the [HOLE PUNCH] button.
• Set other copy modes as required.
5
Press the [START] button.
To Next Page
Loading...
