82
2.HOW TO MAKE COPIES
3.Bypass Copying (Cont.)
2
Recalling dimensions registered in the memory
Press the desired memory number button from [MEMORY 1] to [MEMORY 4] to recall the dimension
data registered previously, and then press the [ENTER] button.
• Paper size that can be set is as follows:
Length: 100 mm (3.94") to 297 mm (11.69")
Width: 148 mm (5.83") to 432 mm (17.01")
• To register the dimension data in the memory, see P.82 “Registering non-standard size in the memory”.
• Set other copy modes as required.
5
Press the [START] button on the control panel.
Registering non-standard size in the memory
1
Follow steps 1 to 3 on “Bypass copying on non-standard size paper”
( P. 8 0 ) .
2
Press the memory number button (from [MEMORY 1] to [MEMORY 4])
you want to register the dimension.
To Next Page
Loading...
