Toshiba e-STUDIO355 - Paper Jam in the Reversing Automatic Document Feeder (Optional) (Lower)

1 TROUBLESHOOTING FOR THE HARDWARE
14 Clearing a Paper Jam
 If paper jams occur frequently
The following are the common causes of paper jams. If the problem persists, check for the following situations.
y An unsuitable original is placed on the Reversing Automatic Document Feeder.
y Unavailable paper with the equipment is used.
y Paper sizes are not consistent between the size in a drawer or the bypass tray and the size registered in the
equipment.
y All the jammed paper has not been removed.
y There is too much of a gap between the paper and the side or end guide in the drawer.
y The amount of paper placed in a drawer exceeds the limit indicated on the side guide of the drawer.
 Paper jam in the Reversing Automatic Document Feeder (optional) (Lower)
1
Open the Reversing Automatic Document Feeder.
2
Open the reverse cover, and remove the original.
3
Close the Reversing Automatic Document Feeder.
4
Raise the lever, and open the upper cover.
1
2