Toshiba e-STUDIO355 - Paper Jam in the Saddle Stitch Finisher MJ-1024 and the Hole Punch Unit MJ-6004 (both Optional)

1.TROUBLESHOOTING FOR THE HARDWARE
Clearing a Paper Jam 29
1 TROUBLESHOOTING FOR THE HARDWARE
 Paper jam in the Saddle Stitch Finisher MJ-1024 and the Hole Punch Unit MJ-6004 (both optional)
When the Hole Punch Unit MJ-6004 is installed
1
Hold up the guide of the paper exit portion and
remove the jammed paper.
When the Hole Punch Unit MJ-6004 is installed, proceed to step 2. If
not, go to step 6.
2
Open the Hole Punch Unit cover.
3
Turn the green knob to locate within the area
indicated on the label.
With the knob set in this position, the punches are up so that paper can
be released.
4
Lift up the Hole Punch Unit and remove the jammed
paper.
1
2
1
2