Toshiba e-STUDIO355 - Cleaning the Hole Punch Dust bin; Hole Punch Unit MJ-6101; MJ-6004; Hole Punch Unit MJ-6005

1 TROUBLESHOOTING FOR THE HARDWARE
Cleaning the Hole Punch Dust Bin 71
Cleaning the Hole Punch Dust Bin
When the hole punch dust bin becomes full, dispose of the paper punchings following the procedure below.
 Hole Punch Unit MJ-6101 / MJ-6004
3
Dispose of the paper punchings.
4
Push back in the hole punch dust bin.
5
Close the Hole Punch Unit cover.
 Hole Punch Unit MJ-6005
1
Open the Hole Punch Unit cover.
2
Pull out the hole punch dust bin.
1
Separate the finisher from the equipment.
Press the lever to unlock the finisher and slowly separate it from the
equipment, placing both of your hands on the front and back of the
finisher.
2
Pull the hole punch dust box out of the Hole Punch
Unit.