Toshiba e-STUDIO355 - Paper Jam in the Bridge Kit (Optional); Paper Jam in the Finisher MJ-1101 and the Hole Punch Unit MJ-6101 (both Optional)

1 TROUBLESHOOTING FOR THE HARDWARE
24 Clearing a Paper Jam
4
Close the Job Separator cover or the Offset Tray cover.
5
Close the automatic duplexing unit.
 Paper jam in the Bridge Kit (optional)
3
Close the Bridge Kit cover.
 Paper jam in the Finisher MJ-1101 and the Hole Punch Unit MJ-6101 (both optional)
Paper Jam in the upper receiving tray
1
Open the cover holding the handle of the Bridge Kit.
2
Remove the paper inside the Bridge Kit.
If the jammed paper cannot be removed because the right side is
caught by the fuser unit, follow the steps on  P.21 “Paper jam in
the fuser unit”.
1
Raise the lever and open the upper receiving tray.