1.TROUBLESHOOTING FOR THE HARDWARE
Refilling With Staples 69
1 TROUBLESHOOTING FOR THE HARDWARE
8
Make sure that the following two requirements are met before test stapling:
y The finisher is securely attached on the equipment.
y A3, B4, A4-R, LD, or LT-R paper is loaded in the drawer
When the message “Check staple cartridge in the Saddle Stitch unit” is displayed, this step is unnecessary.
Proceed to step 9.
9
Close the front cover of the finisher.
When the message “READY (CHECK STAPLER)” is displayed, test stapling starts automatically.
Test stapling is necessary to prevent void stapling. Note that the test stapling starts automatically when the two
requirements in step 8 are met with the front cover of the finisher closed. If the test stapling does not start, make
sure to check the two requirements again. Then open and again close the front cover of the finisher.
To Next Page
Loading...
