Toshiba E-STUDIO600 - Page 19

March 2005 © TOSHIBA TEC e-STUDIO520/600/720/850 SPECIFICATIONS/ACCESSORIES/OPTIONS/SUPPLIES
1 - 7
1
• Eliminated portion .........Leading edges: 3.0±2.0 mm, Side/trailing edges: 2.0±2.0 mm (copy)
Leading / trailing edges: 5.0±2.0 mm, Side edges: 5.0±2.0 mm (print)
• Paper feeding ...............Drawers:
2 drawers + Tandem LCF or 4 drawers (Depends on versions)
- Drawer: Stack height 55 mm, equivalent to 500 sheets; 80 g/m²
(22 lb. Bond)
- Tandem LCF: Stack height 137 mm x 2, equivalent to 2500 sheets; 80 g/m²
(22 lb. Bond)
Bypass feeding: Bypass tray
Stack height 11 mm: equivalent to 100 sheets; 80 g/m² (22 lb. Bond)
Option LCF: MP-4004
Stack height 428 mm: equivalent to 4000 sheets; 80 g/m² (22 lb. Bond)
• Capacity of originals in the reversing automatic document feeder
........................................A3 to A5-R, LD to ST-R:
Stack height 16 mm or less / 100 sheets; 80 g/m² (22lb. Bond)
• Automatic duplexer .......Stackless, Switchback type
• Toner supply .................Automatic toner density detection/supply
Toner cartridge replacing method
(There is a recycle toner supplying mechanism.)
• Density control ..............Automatic density mode and manual density mode selectable in 11 steps
• Weight...........................Approximately 210 kg (463 lb.): NAD, TWD, SAD
Approximately 204 kg (450 lb.): ASD, ASU, AUD, MJD, CND, KRD
• Power requirements......AC 115 V / 16 A, 127 V / 16 A, 220 V or 220-240 V / 9 A (50/60 Hz)
* The acceptable value of each voltage is ±10%
• Power consumption ......2.0 kW or less
* The electric power is supplied to the options through the equipment.
* 1.5 kW or less: TWD version of e-STUDIO520/600/720 only
• Dimensions of the equipment ........... See the figure below (W 698 x D 789 x H 1213 (mm))
69 8 m m
78 9 m m
12 13 mm