Toshiba E-STUDIO600 - Changing Printing Speed

March 2005 © TOSHIBA TEC e-STUDIO520/600/720/850 ADJUSTMENT
3 - 53
3
3.10.5 Changing Printing Speed
When the fuser roller temperature drops drastically during the continuous printing, the printing may be
stopped to increase the fuser roller temperature because the shortage in supply to the fuser unit,
depending of the use condition (use environment, power voltage condition, heat reserve condition of
the fuser unit).
To prevent the printing from stopping or to decrease its frequency, enable the setting of changing the
printing speed when the temperature drops, at the setting mode "08".
<Setting mode(08)>
Notes:
1. This adjustment is valid for e-STUDIO600/720/850.
2. When the setting value "1" is selected, the printing speed slows down if the fuser roller tem-
perature drops for only 5 minutes after the warming-up time.
3. When the setting value "2" is selected, the printing speed slows down if the fuser roller tem-
perature drops.
Code Contents Default Values
858 Changing Printing Speed (Plain paper) 0 0: Disabled, 1: Enabled only for 5min.
2: Always enabled
859 Changing Printing Speed (Thick paper 1) 0 0:Disabled, 1: Enabled only for 5min.
2: Always enabled
860 Changing Printing Speed (Thick paper 2) 0 0:Disabled, 1: Enabled only for 5min.
2: Always enabled
861 Changing Printing Speed (Thick paper 3) 0 0:Disabled, 1: Enabled only for 5min.
2: Always enabled