Toshiba E-STUDIO600 - Self-Diagnosis Modes

e-STUDIO520/600/720/850 ERROR CODE AND SELF-DIAGNOSTIC MODE March 2005 © TOSHIBA TEC
2 - 26
2.2 Self-diagnosis Modes
Note: Note:
To enter the desired mode, turn ON the power while two digital keys designated to each mode
(e.g. [0] and [5]) are pressed simultaneously.
<Operation procedure>
• Control panel check mode (01):
Notes:
1. A mode can be canceled by [POWER] OFF/ON when the LED is lit and the LCD is blinking.
2. Button Check
Buttons with LED (Press to turn OFF the LED.)
Buttons without LED (Press to display the message on the control panel.)
Button on touch panel (Press to display the screen on the control panel at power-ON.)
Mode For start Contents For exit Display
Control panel
check mode
[0]+[1]+
[POWER]
All LEDs on the control panel are lit, and all the
LCD pixels blink.
[POWER]
OFF/ON
-
Test mode [0]+[3]+
[POWER]
Checks the status of input/output signals. [POWER]
OFF/ON
100% C A4
TEST MODE
Test print
mode
[0]+[4]+
[POWER]
Outputs the test patterns. [POWER]
OFF/ON
100% P A4
TEST PRINT
Adjustment
mode
[0]+[5]+
[POWER]
Adjusts various items. [POWER]
OFF/ON
100% A A4
TEST MODE
Setting mode [0]+[8]+
[POWER]
Sets various items. [POWER]
OFF/ON
100% D
TEST MOD
List print mode [9]+[START]
+[POWER]
Prints out the data lists of the codes 05 and 08,
PM support mode and pixel counter.
[POWER]
OFF/ON
100% UA A4
LIST PRINT
PM support
mode
[6]+[START]
+[POWER]
Clears each counter. [POWER]
OFF/ON
100% K
TEST MODE
Firmware
update mode
[8]+[9]+
[POWER]
Performs updating of the system firmware. [POWER]
OFF/ON
-
To exit from Self-diagnosis modes:
Shut down the equipment by pressing the [ENERGY SAVER] button for a few seconds except for
the control panel check mode and the firmware update mode.
[0][1]
[POWER]
LED lit/
LCD blinking
[START]
[START]
(Button check)
[POWER] OFF/ON
(Exit)
05/06