Toshiba E-STUDIO600 - Adjustment of the Scanner Section

March 2005 © TOSHIBA TEC e-STUDIO520/600/720/850 ADJUSTMENT
3 - 37
3
3.7 Adjustment of the Scanner Section
3.7.1 Carriages
[A] Installing carriage wires
When replacing the carriage wires, refer illustrations below:
[Front side]
Fig.3-27
[Rear side]
Fig.3-28
Adjustment of the carriage wire tension is not necessary since a certain tension is applied to the car-
riage wires by the tension springs.
Note: Note:
Make sure the tension applied to the wire is normal.
Carriage-2
Idler pulley
Tension spring
Wire pulley
Bracket for carriage-1
Hook
Carriage wire
Carriage-2
Carriage wire
Bracket for carriage-1
Hook
Wire pulley
Tension spring
Idler pulley