e-STUDIO520/600/720/850 ADJUSTMENT March 2005 © TOSHIBA TEC
3 - 52
3.10.4 High-fusing mode
When the fusing level needs to be raised, it can be set at the setting mode “08“.
(1) Level up at 1st printing
Changing the setting of the pre-running time for first printing
The level is raised by delaying the time for the 1st printing and extending the time to warm the
fuser roller. At this code, the time to delay is set.
<Setting mode(08)>
(2) Level up at continuous printing.
The level for the continuous printing is set at the "high-fusing mode (08-433)". The level is raised
by delaying the printing cycle and controlling not to lower the fuser roller temperature.
The setting of 08-433 is reflected when "Thick paper 3" is selected.
Note: Note:
08-417 of (1) and 08-433 of (2) can be combined.
Code Contents
440 First printing time with plain paper
441 First printing time with thick paper 1
439 First printing time with thick paper 2
417 First printing time with thick paper 3
526 First printing time with OHP
To Next Page
Loading...
