Toshiba E-STUDIO600 - Cautions When Data Overwrite Kit (GP-1060) Is Installed

e-STUDIO520/600/720/850 TROUBLESHOOTING March 2005 © TOSHIBA TEC
5 - 154
(12) Perform 1*-102 (Clearing the image data).
Note: Note:
Following image data are deleted when 1*-102 is performed.
- Images of fax polling transmission
- Images of fax Mailbox and box information
- Images of fax transmission
- Images of fax reception
(13) Turn the power OFF.
(14) Turn the power ON.
(15) Set the dial type. [USER FUNCTIONS] [ADMIN] [FAX] [INITIAL SETUP]
5.3.3 Cautions when Data overwrite kit (GP-1060) is installed
When the Data overwrite kit (GP-1060) is installed, follow the cautions below.
<<Cautions when disposing of the HDD>>
Before disposing of the HDD of the equipment, be sure to perform 08-1426 (forcible HDD data clearing)
and confirm that deleting of the HDD data is completed.
• Check that the percentage is 100% and “HDD Erase [OK]” appears on the upper left of the screen.
• Check that the version (SYS V1.0) is displayed on the lower right of the screen.
* When the scrambler board is installed, data in the HDD are overwritten with encrypted data and
erased.
<<Caution when disposing of the SYS board>>
Before the SYS board is disposed, the following codes can be performed.
• 08-1427 (Forcible NVRAM data all clearing)
• 08-1428 (Forcible SRAM backup data all clearing)
Caution
If these codes are performed, the equipment cannot be started up.
05/11