Toshiba E-STUDIO600 - Adjustment of Reverse Solenoid

e-STUDIO520/600/720/850 ADJUSTMENT March 2005 © TOSHIBA TEC
3 - 62
3.11.5 Adjustment of reverse solenoid
RADF Parts Layout
Refer to "16.13 Disassembly and Replacement [F] Solenoid" for the procedure to disassemble the sole-
noid.
[A] Large original exit roller release solenoid
<Procedure>
(1) Put the end faces of the bracket and solenoid
together.
(2) When the large original exit driven roller con-
tacts the large original exit roller, tighten the
screw B, move the screw A to position C,
temporarily fix it, and shift the solenoid down-
ward..
(3) When the large original exit driven roller and
large original exit roller are disengaged,
tighten and fix the screws.
Fig.3-69
Large original exit solenoid
Small original exit solenoid
Large original exit roller
Large original exit roller release solenoid
Small original exit flapper
Large original exit flapper
Large original exit driven roller
A
B
C
Ends faced-up