March 2005 © TOSHIBA TEC e-STUDIO520/600/720/850 SPECIFICATIONS/ACCESSORIES/OPTIONS/SUPPLIES
1 - 9
1
1.3 Options
* The finisher (MJ-1027/1028) is necessary for the installation of the hole punch unit (MJ-6003N/E/F/
S) and the inserter (MJ-7001).
* The PCI slot (GO-1050) is necessary for the installation of the scrambler board (GP-1040), the par-
allel interface kit (GF-1140) and the fax board (GD-1170NA/EU/AU).
* The antenna (GN-3010) is necessary to enable the wireless LAN module (GN-1040/1041) and the
bluetooth module (GN-2010).
* Up to 2 antennas (GN-3010) can be connected to the wireless LAN module (GN-1040/1041).
* When the wireless LAN module (GN-1040/1041) and the bluetooth module (GN-2010) are installed
together, only 1 antenna (GN-3010) can be connected to each.
Large Capacity Feeder (LCF) MP-4004L/A
Finisher MJ-1027
Saddle stitch finisher MJ-1028
Staple cartridge STAPLE-700
STAPLE-600 (for saddle stitch)
Finisher guide rail KN-1017
Hole punch unit MJ-6003N/E/F/S
Inserter MJ-7001
Damp heater MF-6000U/E
Fax board GD-1170NA/EU/AU
Printer kit GM-1050
Printer/Scanner kit GM-2040
Scanner kit GM-4010
Wireless LAN adapter GN-1040/1041
Bluetooth module GN-2010
Antenna GN-3010
Scrambler board GP-1040
Data overwrite kit GP-1060
PCI slot GO-1050
Parallel interface kit GF-1140
05/11
To Next Page
Loading...
