e-STUDIO520/600/720/850 ERROR CODE AND SELF-DIAGNOSTIC MODE March 2005 © TOSHIBA TEC
2 - 24
2.1.4 Printer function error
Following codes are displayed at the end of the user name on the print job log screen
(when GM-1050/4010 or 2040 is installed)
Error code Contents Troubleshooting
4030 No printer kit / Invalid: When the printer kit or printer/scanner kit is not
installed, network print is performed after the trial period.
Ch.5.1.14 [ 6 ]
4031 HDD full during print: Large quantity image data by private print or invalid
network print are saved in HDD.
Ch.5.1.14 [ 6 ]
4032 Private-print-only error: Jobs other than Private print jobs cannot be per-
formed.
Ch.5.1.14 [ 6 ]
4033 Printing data storing limitation error: Printing with its data being stored to the
HDD temporarily (Proof print, Private print, Scheduled print, etc.) cannot be
performed.
Ch.5.1.14 [ 6 ]
4034 e-Filing storing limitation error: Printing with its data being stored to the HDD
(print and e-Filing, print to e-Filing, etc.) cannot be performed.
Ch.5.1.14 [ 6 ]
4035 Local file storing limitation error: Network FAX or Internet FAX cannot be sent
when "Local" is selected for the destination of the file to save.
Ch.5.1.14 [ 6 ]
4036 User authentication error: The user who intended to print a document is not
registered as a user.
Ch.5.1.14 [ 6 ]
A221 Print job cancellation: Print job (copy, list print, network print) is deleted from
the print job screen.
Ch.5.1.14 [ 6 ]
A222 Print job power failure: The power of the equipment is turned OFF during
print job (copy, list print, network print).
Ch.5.1.14 [ 6 ]
A290 Limit over error: The numbers of output pages have exceeded those speci-
fied with both of the department code and the user code at the same time.
Ch.5.1.14 [ 6 ]
A291 Limit over error: The number of output pages has exceeded the one speci-
fied with the user code.
Ch.5.1.14 [ 6 ]
A292 Limit over error: The number of output pages has exceeded the one speci-
fied with the department code.
Ch.5.1.14 [ 6 ]
To Next Page
Loading...
