March 2005 © TOSHIBA TEC e-STUDIO520/600/720/850 ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 27
2
• Test mode (03): Refer to P.2-28 "2.2.1 Input check (Test mode 03)" and P.2-35 "2.2.2 Output
check (test mode 03)".
• Test print mode (04): Refer to P.2-39 "2.2.3 Test print mode (test mode 04)".
• Adjustment mode (05): Refer to P.2-40 "2.2.4 Adjustment mode (05)".
• Setting mode (08): Refer to P.2-67 "2.2.5 Setting mode (08)".
• List print mode (9S): The procedure varies depending on the code.
• PM support mode (6S):
• Firmware update mode (89): Refer to “6. FIRMWARE UPDATING”.
Fig.2-1
*1 Turn OFF the power after using the self-diagnosis modes, and leave the equipment to the user.
[9][START]
[POWER]
(Code)
101: Adjustment mode (05)
102: Setting mode (08)
(Code)
103: PM support mode
104: Stored information of pixel counter (toner cartridge reference)
105: Stored information of pixel counter (service technician reference)
106: Error history (Maximum 1000 items)
107: Error history (Latest 80 items)
[Digital keys]
Key in the first
code to be printed
[Digital keys]
Key in the last
code to be printed
[POWER] OFF/ON
(Exit)
[START]
List starts to
be printed
[START] [START]
[6][START]
[POWER]
(Code)
1: Auto-toner adjustment
2: PM Support Screen
[START]
(Operation started)
[POWER] OFF/ON
(Exit)
Warming up
Control panel
check mode
Test mode
Test print
mode
Adjustment
mode
Setting
mode
List print
mode
PM support
mode
Firmware
update mode
[POWER]
ON
Normal
Ready
[POWER]
OFF
To user
*1
[0][1] [0][3] [0][4] [0][5] [0][8] [9][START] [6][START] [8][9]
State transition diagram of self-diagnosis modes
To Next Page
Loading...
