e-STUDIO520/600/720/850 ERROR CODE AND SELF-DIAGNOSTIC MODE March 2005 © TOSHIBA TEC
2 - 30
[6]
A Bypass paper size detection sensor-3
(Refer to Table 1)
Bit 1 Bit 0
B Bypass paper size detection sensor-2
(Refer to Table 1)
Bit 1 Bit 0
C Bypass paper size detection sensor-1
(Refer to Table 1)
Bit 1 Bit 0
D Bypass paper size detection sensor-0
(Refer to Table 1)
Bit 1 Bit 0
E - - -
F - - -
G Bypass feed sensor No paper Paper present
H Bypass feed unit cover sensor Cover closed Cover opened
[7]
A Exit cover sensor Cove opened Cover closed
B Exit sensor Paper present No paper
C Fuser transport sensor No paper Paper present
D Reverse sensor-2 No paper Paper present
E Reverse sensor-1 No paper Paper present
F - - -
G - - -
H - - -
[8]
A Tandem LCF connection switch Connected Not connected
B - - -
C Standby side mis-stacking sensor Correct stacking Incorrect stacking
D Standby side empty sensor No paper Paper present
E - - -
F Tandem LCF bottom sensor Bottom position Other than bottom
position
G End fence home position sensor Home position Other than home
position
H End fence stop position sensor Stop position Other than stop
position
[9]
A - - -
B - - -
C - - -
D - - -
E Exit/Reverse section connection Not connected Connected
F Horizontal transport sensor-1 Paper present No paper
G Horizontal transport sensor-2 Paper present No paper
H Horizontal transport sensor-3 Paper present No paper
[0]
A - - -
B - - -
C - - -
D Finisher connection (IPC connection) Not connected Connected
E Fuser unit switch Connected Not connected
F Web motor connection signal Not connected Connected
G - - -
H Developer unit switch Not connected Connected
Digital
key
Button Items to check
Contents
Highlighted display
e.g.
Normal display
e.g.
To Next Page
Loading...
